Welcome to solving the LCD Monitor Syncmaster 743nx problem. I am grateful that you selected my blog and especially this Post. I welcome your comments and “Questions”.

When the PowerLED is blinking in the monitor this means that you have a problem with the Inverter section that uses +12V/+19V to make a High Voltage (voltage depends on the design up to about 180V AC).

You need to use a Higher Voltage AC in the inverter section.

An Inverter makes an AC Voltage turn on Lamps. We know that any LCDScreen has an Inverter for the Lamps (Backlight ).

When the PowerLED is blinking blue that means +12V/+19V is not the correct voltage needed to start the Inverter. Some capacitors are spoiled or the MOSFET has a Short Circuit. When you watch the video, you will be able to see the bulged capacitors.

Someone asked me “Do we have to exchange Capacitors with the same numbers (1000uF,16V)”? My answer is “Absolutely Not”. I prefer to exchange the bulged capacitor with a higher capacity “Voltage” (1000uF,25V).

“How about when the LCD Screen is blinking?” This means that the Inverter OutPut or a Lamp is faulty. In the video the engineer exchanged the Inverter Transformer because he saw that the PCB board around the Transformer was burned.

If you are interested in learning more about electrical repairing or to improve your knowledge, please follow the link and watch the full video and read to end where you will find “A few tips”. A few tips.

Nguồn: https://pius-xii.com/

Xem thêm bài viết khác: https://pius-xii.com/cong-nghe/


  • Ganesh dewasi
    Posted June 29, 2020 8:46 am

    Sir same model h , osme ek dam chalate chalate dicplay or light off ho gai , to muje ab koi solutions melega

  • Ysl Mario
    Posted June 29, 2020 8:46 am

    nice video

  • Dynamic Electronics Services 2
    Posted June 29, 2020 8:46 am


    best service center in Hyderabad

Leave a comment